Bathroom requirements Wet area dry area 1. Wet area and dry area
Must be separated, power control switch must be installed in the dry zone. 2. Shower area floor Shower area floors must be waterproof and covered with non-slip tile. Architectural requirements
3, smallpox thickness luxury head shower, its own net weight of 25KG, the water will reach the shower More than 35KG. Therefore, the thickness of smallpox must be more than 15CM, and smallpox material It has to be strong enough.
4, the height of smallpox must be above 2.3M, so as not to affect the effect of the shower,The aesthetic effect of the bathroom.
5. Wall thickness The wall thickness must be above 15CM to ensure the embedment of the hidden faucet.Install. Requirements for water supply and drainage
6. Hot water supply
Maximum working water pressure :0.8Mpa; Ideal working water pressure :0.25-0.45Mpa; Maximum water temperature :70℃ ; Ideal water temperature: 15℃ -65℃ Minimum hot water allowance: For continuous use of the shower system Numbers are the ultimate determinant; To ensure a person's full enjoyment of the shower system, hot water Minimum barrier at least 250L above.
7. Tap inlet and outlet water connection pipe Mix two 3/4 "(hot and cold) intake pipes and five 1/2" Water outlet pipe
8. Drainage system The minimum displacement of the drainage system is above 60L per minute. Note: All pipes must be drained to remove impurities before connecting to any component of the shower system (faucet, overhead shower, position shower, etc.) to avoid clogging and damage to the shower system components. Requirements for power supply
9. Power Cord 5 the x1. 5 was
10. Power control The switch must be installed in the dry zone Reminder: It is recommended to install fault current protection device, rated current of the safety device 30mA; Sky series lights overhead shower, built-in power transformer to 12V safe voltage.
Author: FOSHAN HUAYUN TECHNOLOGY COMPANY LIMITED
